Control and Placement of Finite-Resolution Intelligent Surfaces in IoT Systems with Imperfect CSI

In this paper, we study the advantages of using reconfigurable intelligent surfaces (RISs) for interference suppression in single-input single-output (SISO) distributed Internet of Things (IoT) networks. Implementing RIS-assisted networks confronts various problems, mostly related to the control and placement of the RIS. To tackle the control-related challenges, we consider noisy and local channel knowledge, based on which we devise algorithms to optimize the potentially distributed RISs to achieve an overall network objective, such as the sum-rate. We use a network with a centralized RIS as a benchmark for our comparisons. We further assume low-bit phase shifters at the RIS to capture real-world hardware limitations. We also study the placement of the RIS and analytically quantify the minimum required degrees-of-control for the RIS as a function of its location to guarantee a specific network performance metric and verify the results via simulations.

Secure Performance Analysis of RIS-aided Wireless Communication Systems

Since Internet of Things (IoT) is suggested as the fundamental platform to adapt massive connections and secure transmission, we study physical-layer authentication in the point-to-point wireless systems relying on reconfigurable intelligent surfaces (RIS) technique. Due to lack of direct link from IoT devices (both legal and illegal devices) to the access point, we benefit from RIS by considering two main secure performance metrics. As main goal, we examine the secrecy performance of a RIS-aided wireless communication systems which show secure performance in the presence of an eavesdropping IoT devices. In this circumstance, RIS is placed between the access point and the legitimate devices and is designed to enhance the link security. To specify secure system performance metrics, we firstly present analytical results for the secrecy outage probability. Then, secrecy rate is further examined. Interestingly, we are to control both the average signal-to-noise ratio at the source and the number of metasurface elements of the RIS to achieve improved system performance. We verify derived expressions by matching Monte-Carlo simulation and analytical results.