Dynamic Power Allocation in OFDM ISAC for Time of Arrival Estimation

Resource allocation in Integrated Sensing and Communication (ISAC) systems is critical for balancing communication and sensing performance. This paper introduces a novel dynamic power allocation strategy for Orthogonal Frequency Division Multiplexing (OFDM) ISAC systems, optimizing communication capacity while adhering to Peak Side-lobe Level (PSL) and sensing accuracy constraints, particularly for Time of Arrival (ToA) estimation. Unlike conventional methods that address either PSL or accuracy in isolation, our approach dynamically allocates power to satisfy both constraints. Additionally, it prioritizes communication when sensing performance is insufficient, avoiding any loss in communication capacity. Numerical results validate the importance of considering both sensing constraints and demonstrate the effectiveness of the proposed dynamic power allocation strategy.

Minimizing Energy Consumption for 5G NR Beam Management for RedCap Devices

In 5G New Radio (NR), beam management entails periodic and continuous transmission and reception of control signals in the form of synchronization signal blocks (SSBs), used to perform initial access and/or channel estimation. However, this procedure demands continuous energy consumption, which is particularly challenging to handle for low-cost, low-complexity, and battery-constrained devices, such as RedCap devices to support mid-market Internet of Things (IoT) use cases. In this context, this work aims at reducing the energy consumption during beam management for RedCap devices, while ensuring that the desired Quality of Service (QoS) requirements are met. To do so, we formalize an optimization problem in an Indoor Factory (InF) scenario to select the best beam management parameters, including the beam update periodicity and the beamwidth, to minimize energy consumption based on users' distribution and their speed. The analysis yields the regions of feasibility, i.e., the upper limit(s) on the beam management parameters for RedCap devices, that we use to provide design guidelines accordingly.

Can 5G NR-Light Operate at Millimeter Waves? Design Guidelines for Mid-Market IoT Use Cases

5th generation (5G) systems have been designed with three main objectives in mind: increasing throughput, reducing latency, and enabling reliable communications. To meet these (often conflicting) constraints, in 2019 the 3GPP released a set of specifications for 5G NR, one of the main innovations being the support for communications in the millimeter wave (mmWave) bands. However, how to implement lower complexity, energy efficient, mid-market Internet of Things (IoT) applications is still an on-going investigation, currently led by the 3GPP which is extending the NR standard with NR-Light specifications to support devices with reduced capabilities (REDCAP). In this paper we investigate the feasibility of operating such devices at mmWaves, in view of the requirements and expectations for NR- Light applications in terms of cost and complexity, throughput, and latency. Contributions of this paper are threefold. First, we il- lustrate the potential of mmWave communication for mid-market IoT use cases. Then, we highlight and motivate the design of an NR-Light candidate interface derived from NR by a selection of features. Finally, we demonstrate the technical soundness of this interface in an industrial IoT setup via simulations.